Bill of Materials (BOM) Take-Off
Run the engine to generate a full material list.
Reference only ? not engineered / not sealed
Jayce is not a licensed engineer. This bill of materials is for estimating and reference only. Jayce assumes no liability for design, fabrication, erection, or construction. Have a licensed professional engineer review and stamp all work before use.
Fill in header fields, run design, then preview or export. Panel colors come from your wall/roof/trim selections on the Dashboard.
BOM PDF Preview
| Length (OAL) | Qty | LF |
|---|
| Length (OAL) | Qty | LF |
|---|
| # | Category | Description | Length (OAL) | Qty | Unit | Wt/Unit | Total Wt |
|---|---|---|---|---|---|---|---|
| Run calculations to build material list... | |||||||
| Bay Sequence No. | Bracing Framework Required | Sidewall Opening(s) |
|---|---|---|
| Run calculations to build structural matrix... | ||
Trim Drawing Set
Catalog + custom submittal sheets for this project. Pitch follows Dashboard. Draw new customs on the Custom Trim tab.
Reference only ? not engineered / not sealed
Jayce is not a licensed engineer. These trim drawings are for estimating and manufacturer submittal reference only. Verify all profiles, hems, and lengths with the panel/trim manufacturer before fabrication.
Automated 2D Shop Drawing Set
Full drawing set - elevations, erection plans, and Rigid Frame Shop primary fab sheets (S0.1-S6.0).
Reference only ? not engineered / not sealed
Jayce is not a licensed engineer. These shop drawings are for estimating and reference only. Jayce assumes no liability for design, fabrication, erection, or construction. Have a licensed professional engineer review and stamp all work before use.
Run & Render Building to generate the 2D shop drawing set.
Drawing Index
Elevations
Plans & Sections
Construction Documents
Dimensioned erection grid, opening schedule, anchor bolt setting plan, and secondary framing schedule - project-specific data from the BOM.
Primary Frame Fabrication
Rigid Frame Shop set - S0.1-S6.0: elevation, column/rafter fab, knee, ridge, base plate. Follows Configure Weld Up / Bolt Up. Strong-axis I | pitch cuts | ES C with pitched flanges.
Frame & Secondary Connection Details
Secondary details (portal, eave). Primary knee/ridge/base are in the fabrication set above.